Wheel Pants

[Mike Darr]

Bill, if you are looking for a very clean and simple way to mate your Bolly pants and gear, you can try a set NMP axles (p/n nmpaxlefg) from Central Hobbies.  The axle set sells for $6.97.  These axles do not use wheel collars.  the wheel is placed on the axle then held in place with a small e clip.  The axle is attached to the gear with a 4-40 bolt threaded through it.  This allows you to put the wheel on the axle then place it inside the wheel pant.  You will have one hole drilled through the gear and wheel pant to allow a 4-40 bolt to pass through.  With this you are simply clamping the wheel pant to the gear when mounting the axle.  This is most likely the lightest set-up that I know of along with a set of Dave Brown wheels.  The only problem is that the axles are made to fit Tetra wheels, so if you choose to use Dave Brown wheels the hub will need to be modified so that the wheel will fit on the axle and still be able to install the e clip.  If you need details on the wheel modification I can explain that in another e-mail.  I can also e-mail you pictures of this set-up if you are interested.

Mike Darr
mdarr00 at comcast.net
NSRCA 3316
  ----- Original Message ----- 
  From: Bill Pritchett 
  To: discussion at nsrca.org 
  Sent: Sunday, December 21, 2003 8:52 AM
  Subject: Wheel Pants


  Thoughts on mounting the Bolly CF pants to the Bolly CF gear??  The pants are grooved to match the outline of the gear......will the axle, mounted with an aircraft nut, prevent rotation of the pants??  Does everyone "capture" the outside of each wheel with a collar, or let it ride against the pants?
  Thanks

  Bill Pritchett
  765-744-9322
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20031221/995eff00/attachment.html