Quests out there

[Kaut, Ken]

My Quest made it's maiden flight this afternoon.  After reading most of the
messages here and on RCUniverse I set my CG between 170-175.  It flies
really well!  I'm a pattern newbie, so take that into consideration.  More
info....mine has a Saito 100 and it does well! The YS110 is probably the
best for this plane.  I already had the Saito.
Happy Holidays to all!
-Ken

-----Original Message-----
From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org] On
Behalf Of John Contreras
Sent: Monday, December 15, 2003 5:35 PM
To: NSRCA List
Subject: RE: Quests out there

Hey Questers,
Is the balance point mentioned in instuctions a good point to start or
should it be further back? I'm about ready to install radio gear and would
like to know. I hope to get mine in the air this weekend.
John   


> [Original Message]
> From: Henderson,Eric <Eric.Henderson at gartner.com>
> To: <discussion at nsrca.org>
 > Date: 12/15/03 4:03:48 PM
> Subject: Quests out there
>
> yeah, I'm still on my "quest", but not alone. Apart from the traffic 
> on = this list, I ran into a notable designer/ builder who had one, 
> broke it = doing low Knife-edges, Bought another and built that. The 
> guys at his = club liked them so much that he ordered 12, yup!, that's 
> twelve. He is = now doing a lot of ARF'ing of Quests for folks.
> 
> Some notes from our data swap.
> 
> 1. 2-c's make it tail heavy, Put servos in middle (Not in tail) 2. YS 
> 1.10 is the best motor for it 3. Works just fine with hard wood 
> bearers.
> 4. Quieter with Hydemount.
> 5. There is a 1.10 ARI mount
> 6. Tail-wheel wire breaks - use alternative name brand, e.g. DuBro.
> 
> Regards,
> 
> Eric.
> =20
> 
> =====================================
> # To be removed from this list, send a message to # 
> discussion-request at nsrca.org # and put leave discussion on the first 
> line of the body.
> #



--- John  C
--- jacontrera at earthlink.net


=====================================
# To be removed from this list, send a message to #
discussion-request at nsrca.org # and put leave discussion on the first line of
the body.
#
=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#