vinyl-ester, PL and ZN kits

[Koenig, Tom]

Hi all,

I think I asked something along these lines a few years ago but.........
anyway.
I have a neighbour who owns a panel shop and he just offered me the use of
his booth to do the clear coat. Now, ZN and Pl kits are vinyl-ester resin (
correct?). What temperature can I ( safely)  crank the booth up to, to force
dry the clear? I dont want to end up with an expensive, colourful, blob of
carbon and kevlar on the floor of the spray booth!

Matt... I seem to remember you mentioned something about this...Gray..I
guess you would know the GT etc?

I was tending to head for a safe temp around 40-45 deg C ( 104-113 deg F)
Can I go to 60?

Thanks for any help

Tom

PS: never had these problems with wood!

************************************************************************
*PLEASE NOTE*  This email and any attachments may
be confidential. If received in error, please delete all 
copies and advise the sender. The reproduction or 
dissemination of this email or its attachments is 
prohibited without the consent of the sender.

WARNING RE VIRUSES:  Our computer systems sweep
outgoing email to guard against viruses, but no warranty 
is given that this email or its attachments are virus free. 
Before opening or using attachments, please check for 
viruses.  Our liability is limited to the re-supply of any 
affected attachments.

Any views expressed in this message are those of the 
individual sender, except where the sender expressly,
and with authority, states them to be the views of the 
organisation.
************************************************************************
=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#