YS .91 idle setting

[Keith Hoard]

I've got 15% cool power (green), guess I need to get some fuel with more "oomph".  I'm going out to mess with it tomorrow and will try the regulator.  

I was looking on the YS engine forum on RC Universe and Dave Shadel stated that the regulator doesn't have any influence on the top or bottom of the RPM range, only the mid-range.  Can anyone else here confirm that??


Keith L. Hoard
Cordova, TN
klhoard at midsouth.rr.com
  ----- Original Message ----- 
  From: Terry Brox 
  To: discussion at nsrca.org 
  Sent: Monday, April 07, 2003 6:50 PM
  Subject: Re: YS .91 idle setting


  You might try turning the regulator in. To get my 91AC to idle, I had to turn the regulator in nearly 3/4 of a turn and idle out 1 1/2 turns. Ran great after that. What nitro are you running? You need a minimum 20%, and 30% is better yet.
    ----- Original Message ----- 
    From: Keith Hoard 
    To: discussion at nsrca.org 
    Sent: Monday, April 07, 2003 5:12 PM
    Subject: Re: YS .91 idle setting


    Yup, got that. . . left is lean, right is rich. . . Just came in from messing with the low speed needle and it is set good for the transition, but it still won't idle for more than 20-30 seconds.  I run it full throttle for about 10 seconds to pressurize the tank then drop it to idle - 2000 to 2400 RPM.  The engine idles at this speed for about 20-30 seconds then the RPM slowly decays until it quits, then fuel drips out of the carb (engine inverted).  I relight the glow plug, spin the engine and it starts right up again and repeats.



    Keith L. Hoard
    Cordova, TN
    klhoard at midsouth.rr.com 
      ----- Original Message ----- 
      From: Terry Brox 
      To: discussion at nsrca.org 
      Sent: Monday, April 07, 2003 5:03 PM
      Subject: Re: YS .91 idle setting


      Low speed is an airbleed. Out is leaner, in is richer. Opposite from the high speed.
        ----- Original Message ----- 
        From: Keith Hoard 
        To: NSRCA Mailing List 
        Sent: Monday, April 07, 2003 4:51 PM
        Subject: Fw: YS .91 idle setting



        From: Keith Hoard 
        To: NSRCA Mailing List 
        Sent: Monday, April 07, 2003 3:06 PM
        Subject: YS .91 idle setting


        Gentlemen,

           I'm breaking in my YS .91FZ and seem to have gotten the top end working fine, but the engine idles at 2000 RPM for about 10 seconds then slowly dies.  I don't remember which way to turn the low speed needle, and the YS Performance page seems to have been hijacked.  Thanks!!




        Keith L. Hoard
        Cordova, TN
        klhoard at midsouth.rr.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20030407/da2a4cb6/attachment.html