OS 1.40 rear bearing replacement

[Mike Hester]

Yes, I live! =P

-Mike
  ----- Original Message ----- 
  From: Rcmaster199 at aol.com 
  To: discussion at nsrca.org 
  Sent: Thursday, April 03, 2003 5:36 PM
  Subject: Re: OS 1.40 rear bearing replacement


  In a message dated 4/3/2003 8:26:36 PM Eastern Standard Time, kerlock at attbi.com writes:



    Subj:Re: OS 1.40 rear bearing replacement 
    Date:4/3/2003 8:26:36 PM Eastern Standard Time
    From:kerlock at attbi.com
    Reply-to:discussion at nsrca.org
    To:discussion at nsrca.org
    Sent from the Internet 



    Hey Bryan,

    Just stick it in the oven at about 350, give it about 10-15 minutes, then
    take it out...quickly...and smack it on a block of wood. The bearing will
    fall out. Oh uh use a potholder or something =) Teehee.

    Then tap the front one out with a 1/2" dowel.

    When you put the new ones in, oil them, then heat the case again...and
    freeze the bearings. Put the front bearing in first, then put the rear on
    the crank and slap it in place.

    Then oil the crap out of the whole thing. it's just that easy.

    -Mike




  Welcome back Mike,

  Good to see you back on the discussion board

  Matt 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20030403/2c765322/attachment.html