The MASTERS 2005 PROPOSED ROUTINE THAT YOU VOTED FOR.

Tony Stillman tony at radiosouthrc.com
Wed Sep 25 14:01:28 AKDT 2002


I agree.  I also think the Pyramid loop should be a 3K, as it is not very
difficult at all.  Also #11 should be a 2K, as it is easier than a humpty
bump!

Tony Stillman
Radio South, Inc.
3702 N. Pace Blvd.
Pensacola, Fl 32505
www.radiosouthrc.com
800-962-7802
----- Original Message -----
From: "Tomanek, Wojtek" <tomanekw at saic-abingdon.com>
To: <discussion at nsrca.org>
Sent: Wednesday, September 25, 2002 1:20 PM
Subject: RE: The MASTERS 2005 PROPOSED ROUTINE THAT YOU VOTED FOR.


Should the maneuver # 9  (9. Half Inside Loop, 2/4 on exit K=1) be rated
K=2, comparing to an Immelman which is K=2?

WKT

-----Original Message-----
From: Henderson,Eric [SMTP:eric.henderson at gartner.com]
Sent: Wednesday, September 25, 2002 12:27 PM
To: Discussion at Nsrca. Org
Subject: The MASTERS 2005 PROPOSED ROUTINE THAT YOU VOTED
FOR.

2005 Masters proposal.

1. Takeoff (U) K=1

2. Stall Turn 1 ¼ Rolls Up, ¾ Roll Down, Exit Inverted (U) K=4

3. Half Outside, 2/4 K=2

4. Reverse Avalanche with 1 positive snap @ Bottom (D) K=4

5. 1/2 loop with full Roll Out K=2

6. 45 degree Pyramid Loop with Half Rolls (U) K=4

7. Humpty Bump, ¼  Roll Up, ¾ Roll Down  K=3

8. Quarter, Half, Quarter Roll (D) K=4

9. Half Inside Loop, 2/4 on exit
K=1

10. Square Eight from the Middle, Pilot's Option (U)
K=4

11. Figure nine - pull loop first, 1/2 roll down
K=3

12. Slow Roll (D) K=3

13. Pull-Push Humpty Bump with Pilot's Option  K=2

14. Square Loop with 2/4 Rolls on all side (U) K=5

15. Stall Turn With Half Rolls K=2

16. Inside-Outside Diamond Eight with Full Rolls (D)
K=5

17. Immelmann Turn K=2


18. 45 Degree Down, Positive Snap Roll (U) K=3

19. Top Hat with ¾ Roll Up, ¼ Roll Down, Exit Upright K=3

20. Knife-edge to knife-edge (D) K=4

21. Half Square Loop with 1/2  Roll Up K=2

22.  Spin, 2 1/2 Turns, Half Roll Out, Exit Upright (U) K=4

23. Landing (U)  K=1


====================================# To be removed from this list,
send a message to
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#
============# To be removed from this list, send a message to
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#




=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#



More information about the NSRCA-discussion mailing list