monokote adhesive removal

[Bob Pastorello]

I would be VERY careful using Acetone, as I've had it dull the shine on
areas of Monokote...the best bet is Monokote Trim Solvent...IMHO.

Bob p.
----- Original Message -----
From: "Amir Neshati" <amirn at flash.net>
To: <discussion at nsrca.org>
Sent: Sunday, September 22, 2002 9:34 AM
Subject: Re: monokote adhesive removal


> A little Ironex will remove those Monokote stains from the iron.....It
will
> also
> clean the same stains that get back on the covering from the
iron....Ironex
> is
> a reducer for Balsarite and is sold in most hobby shops...Lacquer thinner
> might
> work too.
>
> Have fun,
> Amir
> ----- Original Message -----
> From: "Chuck Czarnik" <cczarnik at arclp.com>
> To: <discussion at nsrca.org>
> Sent: Sunday, September 22, 2002 6:16 AM
> Subject: monokote adhesive removal
>
>
> > Anybody got a tip from removing a little smeared monokote adhesive that
> came
> > off of my iron onto the finish?
> > =====================================
> > # To be removed from this list, send a message to
> > # discussion-request at nsrca.org
> > # and put leave discussion on the first line of the body.
> > #
>
> =====================================
> # To be removed from this list, send a message to
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #
>

=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#