Fiberglass Question - Please Educate me !

[Gray E Fowler]

Van

Use the coupler, it will be much easier to release. Apply 4 coats of real 
car wax to the coupler, this will release. There are better releases but 
you will have to buy a pretty big quantity. The real problem here is no 
matter what the release, the physical configuration you are molding is by 
far the hardest to get off the mold. The best way to remove a molded ring 
on a male mold is to push it off. This requires something that will push 
the inside (such as a piece of pvc pipe) while something hold the outside 
ring on a arbor press or similar. Hammering does not work real well. You 
may be able to glue in the pipe to  the coupler, then use something like 
and oil filter wrench to twist the ring off.
It will have the natural spring back you desire.
Carbon fiber will work just like the fiberglass other than the fact it 
will be 3X stiffer.  Check www.cstsales.com for carbon fiber and other stuff.


Gray Fowler
Principal Chemical Engineer
Composites Engineering




"Van - E-Mail LIST" <extra330 at tampabay.rr.com>
Sent by: discussion-request at nsrca.org
09/10/2002 07:58 PM
Please respond to discussion

 
        To:     "Pattern LIST" <discussion at nsrca.org>
        cc: 
        Subject:        Fiberglass Question - Please Educate me !


Gray / Lance / All,
 
I need to know what type of epoxy and release agent ( if I need that ) to 
get to make some fiberglass rings. Let me describe what I am trying to 
make, and tell me if I am totally off base here, and what I need to do to 
accomplish my task, if you can.
 
I need to make about "6" Fiberglass rings. They need to be 4" in diameter, 
and about 2" wide. I have some 2" wide fiberglass cloth that is fairly 
heavy, and I plan to use that for the material. When they dry, I need to 
be able to make cut in them, so the ring can be spread open, and the ring 
needs to have some "spring back" to it, just slightly, so it needs to be 
sorta stiff.
 
I have found that a 3 1/2" PVC coupler is a perfect side for the ring if I 
wrap the material on the outside. So is a glass Miracle Whip jar ( ;-) - 
Hey guys, I'm not a glass guru, but I do have a degree in MacGyver ! )
 
Can I put release agent on the coupler, or the far, wrap my glass on this, 
and will it work ?
 
What working time epoxy do I need ?
Would Carbon Fiber Tape be better ?
Where should I get it ?
How much is a round trip ticket to your workshop so you can teach me ??? < 
bigger grin >
 
I truly appreciate any help you can give. I can also send you pictures of 
a mock up that I did, not full size, but will give you the idea.
 
Van
 
________________________________________________
 
Van Flowers
AMA: 6216 IMAC: 2229 
IMAA: 26019 NSRCA: 2778
www.rc-aerobatics.com
 
 
 
 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20020911/ccf009f3/attachment.html