YS bearing replacement

[Anthony Romano]

Great point! However, Mine usually get bathed in fuel the day after they are 
changed.

Anthony






>From: s.vannostrand at kodak.com
>Reply-To: discussion at nsrca.org
>To: discussion at nsrca.org
>Subject: RE: YS bearing replacement
>Date: Wed, 23 Oct 2002 09:25:30 -0500
>
>Anthony,
>That's a sure way to put condensation on the bearings and shorten their
>life!
>--Lance
>
>
>
>
>
>"Anthony Romano" <anthonyr105 at hotmail.com>
>Sent by: discussion-request at nsrca.org
>10/23/2002 08:09 AM
>Please respond to discussion
>
>
>         To:     discussion at nsrca.org
>         cc:
>         Subject:        RE: YS bearing replacement
>
>
>
>
>
>I will also throw the bearings in the freezer for a few minutes to make
>installation a little easier.
>
>Anthony
>
>
>
> >From: "Ronald H. Filteau" <filteau at sk.sympatico.ca>
> >Reply-To: discussion at nsrca.org
> >To: discussion at nsrca.org
> >Subject: RE: YS bearing replacement
> >Date: Tue, 22 Oct 2002 20:23:36 -0600
> >
> >Hi Dave
> >
> >I replace my bearings by removing all rubber and plastic parts first of.
> >I then remove the crank shaft.  Put engine in oven at about 400 d  for
> >about 20 minutes and then gentle tap the back on some soft would.  The
> >bearings should drop right out.  I then use a dowel of wood to gentle
> >tap out the front bearing.  Repeat the order when replace the bearings
> >Heat the case and use the crank shaft to line the bearings in to place.
> >Use the thrust washer and old prop to pull the bearings into place.
> >
> >Ron F
> >
> >-----Original Message-----
> >From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]
> >On Behalf Of NSRCA Canada-West
> >Sent: Tuesday, October 22, 2002 7:30 PM
> >To: discussion at nsrca
> >Subject: YS bearing replacement
> >
> >OK YS experts out there in cyber space...
> >
> >I am about to install a replacement main bearing in my 140L. Any
> >comments or thoughts as to the "best" way of doing this without causing
> >any grief.
> >
> >Thanks in advance.
> >
> >Dave
> >
>
>
>_________________________________________________________________
>Internet access plans that fit your lifestyle -- join MSN.
>http://resourcecenter.msn.com/access/plans/default.asp
>
>=====================================
># To be removed from this list, send a message to
># discussion-request at nsrca.org
># and put leave discussion on the first line of the body.
>#
>
>
>


_________________________________________________________________
Get a speedy connection with MSN Broadband.  Join now! 
http://resourcecenter.msn.com/access/plans/freeactivation.asp

=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#