2005 Masters
Anthony Romano
anthonyr105 at hotmail.com
Tue Oct 22 12:17:28 AKDT 2002
>From: "Henderson,Eric" <eric.henderson at gartner.com>
>
>One thing I did note was that you must push the box with mid entry fig-9 to
>leave room for the slow roll
That is my only complaint for the sequence. The rest is pretty fun. Will
have to practice it alot to roll correctly in all the turn arounds. Luckily,
I have lots of time before that is a concern.
Test flew my Focus on Sunday and on the second flight did a reverse
avalanche but started upright. Got to the bottom and did a positive snap
low, slow and inverted! Talk about pucker factor! Got lucky and pulled it of
unscathed. Really could get to like this plane.
Anthony
>
>-----Original Message-----
>From: Anthony Romano [mailto:anthonyr105 at hotmail.com]
>Sent: Thursday, October 03, 2002 9:12 AM
>To: discussion at nsrca.org
>Subject: RE: 2005 Masters
>
>
>
>Eric,
>I get it now! Sort of a diamond cuban eight. I was doing the maneuver
>vertically.
>
>Anthony
>
> >From: "Henderson,Eric" <eric.henderson at gartner.com>
> >Reply-To: discussion at nsrca.org
> >To: discussion at nsrca.org
> >Subject: RE: 2005 Masters
> >Date: Wed, 2 Oct 2002 08:51:47 -0400
> >
> >Anthony,
> > A 1/4 loop is 90 degrees. A 1/8 loop is 45 degrees.
> >
> >A diamond 8 has one 1/8 loop, then two 1/4 loops, one inverted roll on
>the
> >45 down line, then three 1/4 outside loops, one upright roll on the 45
>down
> >line and then 1/8 loop to pull out to level flight.
> >
> >Best idea would be to draw this and then count them.
> >
> >
> > /\ /\
> > / \/ \
> > \ /\ /
> > >____\/ \/____>
> >Eric.
> >
> >
> >
> >
> >Anthony Romano wrote:
> >
> > > Hi Eric,
> > > Two questions
> > >
> > > >Stall Turn 1 and 1/4 Rolls up, 3/4 Roll down, Exit Inverted
> > > >Model pulls through one-quarter (1/4) loop to vertical flight,
> > > >pauses, performs one-and-one-quarter (1-1/4) rolls,
> > > >pauses, performs a 180 degree stall turn in the direction
> > > >of the maneuver to a vertical dive, pauses, performs
> > > >a three-quarter (3/4) roll in opposite rotation, pauses, then pushes
> > > >through one-quarter (1/4) loop to recover in inverted level
> > > >flight.
> > > >Downgrades:
> > > >1. Track not vertical at beginning and end of rolls
> > > >and stall turn.
> > > >2. Track of stall turn not 180 degrees.
> > > >3. Over or under rotation of rolls. 1 Point per 15
> > > >Degree Rule.
> > > >4. Rolls not centered in vertical lines.
> > > >5. Loop segments not round and of equal radius.
> > > >6. Pendulum movement after stall.
> > > >7. Exit not same altitude and heading as entry.
> > > >8. Roll rates not constant.
> > > >
> > >
> > > Sorry, I took my rule book out of my briefcase so I can't look this up
> >my
> > > self. There was a question at the judging seminar earlier this year
> >about
> > > less than 180 degrees of track when wind corrected. Has this been
> >resolved
> > > or specified in another section?
> > >
> > > >>
> > > >Inside-Outside Diamond Eight with 1/1, Full Rolls, on center 45's
> > > >Model passes through center and pulls one eighth (1/8) loop to
> > > >45 degree up line, draws another straight line then pulls quarter
>(1/4)
> > > >loop, draws straight line and pulls one quarter loop (1/4). Model
> >hesitates
> > > >and performs one roll (1/1), hesitates and pushes one quarter loop
> >(1/4)
> >to
> > > >45 degree up line, draws line and then pushes one quarter loop (1/4),
> >draws
> > > >straight line, pushes one quarter loop (1/4), hesitates and performs
> >one
> > > >roll (1/1), hesitates pulls one-eighth loop (1/8) to level flight.
> > > >Downgrades.
> > > >
> > >
> > > <<<<I think you need another pull quarter loop after the role or you
> >wind
> >up
> > > on
> > > a verticle downline.>>>>
> >
> >I arrive at the same conclusion, Anthony.Georgie
> >
> > >
> > >
> > > Anthony
> > >
> > > _________________________________________________________________
> > > MSN Photos is the easiest way to share and print your photos:
> > > http://photos.msn.com/support/worldwide.aspx
> > >
> > > =====================================
> > > # To be removed from this list, send a message to
> > > # discussion-request at nsrca.org
> > > # and put leave discussion on the first line of the body.
> > > #
> >
> >
> >
> >=====================================
> ># To be removed from this list, send a message to
> ># discussion-request at nsrca.org
> ># and put leave discussion on the first line of the body.
> >#
> >=====================================
> ># To be removed from this list, send a message to
> ># discussion-request at nsrca.org
> ># and put leave discussion on the first line of the body.
> >#
>
>
>
>
>_________________________________________________________________
>Join the world's largest e-mail service with MSN Hotmail.
>http://www.hotmail.com
>
>=====================================
># To be removed from this list, send a message to
># discussion-request at nsrca.org
># and put leave discussion on the first line of the body.
>#
>=====================================
># To be removed from this list, send a message to
># discussion-request at nsrca.org
># and put leave discussion on the first line of the body.
>#
_________________________________________________________________
Surf the Web without missing calls! Get MSN Broadband.
http://resourcecenter.msn.com/access/plans/freeactivation.asp
=====================================
# To be removed from this list, send a message to
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#
More information about the NSRCA-discussion
mailing list