dual receivers.....range

[Richard Hallett]

Twist them all.

It takes nothing much to knock them out if it accidentally is done right.

Worst offenders are loops near or wires passing around the receiver.
Frequently by simply pulling all the wires away to the far ends of the plane
away from the receiver will work wonders.

There are hard cases.

Rick
----- Original Message -----
From: "Bill Brittain" <whbrittain at attbi.com>
To: <discussion at nsrca.org>
Sent: Monday, October 21, 2002 9:46 PM
Subject: RE: dual receivers.....range


> Try twisting the leads going back to the elevator servos.  About 2 twists
> per inch worked well for me.
>
> Bill Brittain
> Mt. Prospect, IL
> whbrittain at attbi.com
> -----Original Message-----
> From: discussion-request at nsrca.org
> [mailto:discussion-request at nsrca.org]On Behalf Of Brian Young
> Sent: Monday, October 21, 2002 8:30 AM
> To: discussion at nsrca.org
> Subject: dual receivers.....range
>
>
> Im setting up a plane w/ dual receivers and my range
> check seems very short, about 30 paces or a bit less.
> This is w/ a Futaba 8uap, and pcm receivers. It seems
> like if i disconnect the elevator servos, which are in
> the tail, my range improves.
>
> Its on a bigger plane w/ 10 servos, leads everywhere.
>
> Anyone have any tips on improving the range or anyone
> running dual futaba receivers? Do those chokes that
> can be put on the servo leads help?
>
> Sorry this is a bit off topic, just curious if anyone
> has any experience w/ this setup.
>
>
>
>
>
> =====
> Brian Young
> Tulsa
> b4598070 at yahoo.com
> 918-745-6046h
> 918-838-0900w
>
> __________________________________________________
> Do you Yahoo!?
> Y! Web Hosting - Let the expert host your web site
> http://webhosting.yahoo.com/
> =====================================
> # To be removed from this list, send a message to
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #
>
>
> =====================================
> # To be removed from this list, send a message to
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #
>

=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#