CF pipe mounting?

[Terry Brox]

I still have some from an old Hatori 650. I will be mounting the pipe next week, I appreciate all the ideas, Thanks again, Terry
  ----- Original Message ----- 
  From: Tony Stillman 
  To: discussion at nsrca.org 
  Sent: Monday, November 04, 2002 10:49 AM
  Subject: Re: CF pipe mounting?


  I have had the brass break as well, that is why I use the steel clamps from the Hatori pipes.  I have these in stock, if interested.

  Tony Stillman
  Radio South, Inc.
  3702 N. Pace Blvd.
  Pensacola, Fl 32505
  www.radiosouthrc.com
  800-962-7802
    ----- Original Message ----- 
    From: Terry Brox 
    To: discussion at nsrca.org 
    Sent: Monday, November 04, 2002 9:52 AM
    Subject: Re: CF pipe mounting?


    Thanks Tony,
                 That is what I had in mind, is there a strap available or  is it best to fashion my own. This is the same way I usually mount my pipe using the lords mount from the Sullivan soft mount kit. I usually just use brass shim stock but that has failed before, and I am not sure how much pressure the CF can take when tightening down the clamps.
    Thanks again, Terry 
      ----- Original Message ----- 
      From: Tony Stillman 
      To: discussion at nsrca.org 
      Sent: Monday, November 04, 2002 8:13 AM
      Subject: Re: CF pipe mounting?


      Terry:

      I use a "lord mount" on it.  I attach a strap around the back of the pipe, just forward of the stinger.  The strap attaches to the lord mount via a 8-32 bolt.

      I use the same set-up on the front of the pipe, where the teflon attaches to the pipe.  A strap, then a piece of brass tubing to make a bushing to get the proper height, then a long screw to go through the strap, bushing, and into the lord mount.

      Never had any breakage using a Hyde mount.

      Tony Stillman
      Radio South, Inc.
      3702 N. Pace Blvd.
      Pensacola, Fl 32505
      www.radiosouthrc.com
      800-962-7802
        ----- Original Message ----- 
        From: Terry Brox 
        To: discussion at nsrca.org 
        Sent: Saturday, November 02, 2002 9:40 PM
        Subject: CF pipe mounting?


        I would like some ideas from those using the Carbon Fiber tune pipes (4 stroke), how to mount. I have heard they can be fragile, so I need some ideas. Thanks in advance, Terry

        PS I will be using at least 7" of teflon between pipe and header (9" overall coupler length).
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20021104/19e425d2/attachment.html