Help Futaba 9Z

David Harmon k6xyz at attbi.com
Mon Dec 16 13:57:56 AKST 2002


Linda....let me correct myself.....Inhibit your previous PMX. Activate
ALV, set aileron travel to 0 (in ALV),
Plug aileron servos into chans 2 & 5.
Plug retract servo into chan 9. Go to CH9 function in tx, choose switch.
Done.
Dave

-----Original Message-----
From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]
On Behalf Of David Harmon
Sent: Monday, December 16, 2002 2:32 PM
To: discussion at nsrca.org
Subject: RE: Help Futaba 9Z


Linda....move the retract channel function using FNC from chan 5 to an
unused channel. Then, activate ALV which uses chans 2 & 5 for elevators.
Set aileron travel to 0 (in ALV) Inhibit the other PMX you tried to use.
Works good.... Dave

-----Original Message-----
From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]
On Behalf Of Linda Carnes
Sent: Monday, December 16, 2002 1:07 PM
To: discussion at nsrca.org
Subject: RE: Help Futaba 9Z


Has any one set up a futaba 9Z to use channels 2 and 8 for the
elevators. I can not use channel 7 as it operates the OS engine ECU. It
currently tries to hit channel 5 which is the gear servo.

I have had some luck using the program mix but I get little up and about
90% down

Sincerely

Linda Carnes


Combined PC Support Services Inc.
Phone: (706) 253-7677
Toll Free: (866) 286-2379
Fax: (706) 253-7679
Cell Phone:(770) 401-7634
Pager: (770)735-5691
E-Mail: lac at mypccrashed.com
Corp. Web Page: <http://www.mypccrashed.com>



=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#



=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#



=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#



More information about the NSRCA-discussion mailing list