Need Focus Help

[Bill Glaze]

That's supposed to be Forster bit.......I guess I hurriedly believed my spell
checker. Sorry.  Bill Glaze

Bill Glaze wrote:

> Steve:
> Don't know about others, but here's what I did:
> After cutting the motor box down by 3/4", I had to cut down the top and bottom
> plates by a like amount.  Be careful to preserve the angles.
> Now, you have no place to easily access the blind nuts for the firewall from
> the inside.  So, I used a small frostier bit, and cut holes in the top plate.
> These give me access to the blind nuts for the engine mount.  Put them over the
> pre drilled hole, hold them near the hole with forceps, and seat them by
> running a bolt through the firewall, and engaging the blind nuts.  After the
> blind nuts are seated, you're ready to go.  I'm sure it's not the only way,
> maybe not even the best way, but it worked well for me.  HTH.
> Any other questions, ask away.
>
> Bill Glaze
>
> RC Steve Sterling wrote:
>
> > Hi Focus Assemblers--
> > In the instructions for the motor box, it says "Reinforce the front of the
> > motor box with the supplied plates (fig.15)."
> >
> > The picture of fig. 15, it looks like they are putting the plate on the top
> > and bottom of the box. Also, the plates aren't large enough to fit on the
> > front plate.
> >
> > So what did others do? Interpretation?
> >
> > Steve
> >
> > =====================================
> > # To be removed from this list, send a message to
> > # discussion-request at nsrca.org
> > # and put leave discussion on the first line of the body.
> > #
>
> =====================================
> # To be removed from this list, send a message to
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #

=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#